Pallet Rack Permit Checklist

Design Guidance Utah adopted codes:
2009 IBC, Sections: 1705.3, 1707.5,2208.1. 2009 IFC Chapters 23

A building permit is required for racking exceeding 5’ 9” in height per IBC Section 105.2. Due to all of Salt Lake City being within seismic
design categories D or E, Special Inspections are required for storage racks 8’ or greater in height.

IBC 1707.5: Storage racks and access floors.

Periodic special inspection is required during the anchorage of access floors and storage racks 8’ or greater in height in structures assigned to Seismic Design Category D,E, or F. Special Inspections (per IBC Chapter 17):
An SI form is available at Room 215 must be completed in full prior to permit issuance:
www.slcgov.com/CED/buildzone/specinsptest.pdf

General Requirements

A: Submit TWO copies of all drawings, specifications, and calculations.
B: Drawings (1/4” or larger scale is preferred) are to include but to include but are not limited to:
1) Floor plan drawing of building area of larger building for interior racking.
2) Site plan drawing for exterior racking. Note: The exterior rack
storage maximum height is 20’.
3) Exit paths. Include all building exits and where the exits lead
to (i.e. to the public way).
4) Layout of racking including aisle dimensions (3’, 8’, or 12’)
5) Full-height elevations or section drawing from floor to roof. Include the
following heights from floor level:
Maximum height of the rack’s top shelf.
Maximum height of commodities stored on the top shelf.
Sprinkler heads.
Bottom of roof structural members.
Bottom of roof deck.
6) Details:
Floor bolt and washer (leveling shims) specifications and sizes.
Connections of upright to upright, row to row, back to back, etc.
7) Provide the manufacturer’s specifications
/ installation instructions.
C: A Utah licensed engineer’s stamp (signed and dated) is required for racks 8’ or greater in height. The drawings and calculations (including seismic requirements for SLC) shall be stamped. Racks less than 8’ in height shall
be installed per manufacturer’s specifications.
D: The following information is needed to complete a plan review of high pile and rack storage. If the commodities that are stored are flammable or pyrophoric in nature, these additional requirements will be applied:
1) Provide the type of commodities that are stored (steel, cardboard
boxes, plastic, tires, etc.)
2) Is the storage interior or exterior? Provide information about the storage shelves (i.e. solid, board planks, open metal grid, etc.).
3) Provide information regarding how the commodities are placed on the racks. (loose on pallets, in cardboard boxes with plastic shrink wrap around and/or over the top of the boxes, in metal bins, etc.
4) Is the building equipped with fire sprinkler protection? If so, include the
density rate of the sprinkler system. Also include showing the zones of
the sprinkler system. Commodities stored 12’ or higher require sprinklers,
regardless of the area of the room or building. Buildings built prior to 1995
usually do not have Early Suppression Fast Response (ESFR) sprinkler heads.
5) Will the stored materials be automatically or manually placed?
6) A man door is required every 100’ along the exterior wall adjoining the racking area.
7) The Salt Lake City Fire Prevention Bureau shall be notified three working days in advance to conduct the inspection of all fire suppression and fire alarm systems.
8 A fire department hose outlet, 1.5”, shall be required at EACH of
the fire department access door serving the racking area.

APPROVALS REQUIRED FOR PERMIT ISSUANCE

Building Code
Fire Department
Zoning
All are located in room 215, City and County
Building, 415 South State St. (801) 535-600.

PERMIT FEES

The permit fees are based upon the valuation assessed for this racking installation project. The value of new or used racks (purchased for
this project) is to be included in the valuation. In addition to this material value, the total shall also include the total labor cost.
Our fee schedule can be found on our website; www.slcpermits.com

Serving These Counties in the Salt Lake City Area:

Davis County, Duchesne County, Morgan County, Salt Lake County, Summit County, Tooele County, Utah County, Wasatch County, Weber County.

Serving These Zip Codes in the Salt Lake City Area:

84004, 84005, 84006, 84010, 84013, 84014, 84015, 84020, 84025, 84032, 84036, 84037, 84040, 84040, 84041, 84042, 84043, 84044, 84047, 84049, 84050, 84054, 84056, 84057, 84058, 84060, 84062, 84065, 84067, 84070, 84071, 84074, 84075, 84084, 84087, 84088, 84092, 84094, 84095, 84096, 84097, 84098, 84101, 84102, 84103, 84104, 84105, 84106, 84107, 84108, 84109, 84115, 84116, 84117, 84118, 84119, 84120, 84121, 84123, 84124, 84128, 84141, 84310, 84315, 84340, 84401, 84403, 84404, 84405, 84601, 84602, 84604, 84606, 84651, 84653, 84663, 84664.

Serving these Cities in the Salt Lake City Area:

American Fork, Bingham Canyon, Bingham Cyn, Bluffdale, Bountiful, Brigham City, Castle Dale, Cedar Hills, Centerfield, Clearfield, Cleveland, Clinton, Cottonwood Heights, Draper, Eagle Mountain, Eagle Mtn, Fairfield, Farmington, Fruit Heights, Grantsville, Heber City,Herriman, Highland, Holladay, Honeyville, Hooper, Huntsville, Kamas, Kaysville, Layton, Lehi, Lindon, Logan, Midvale, Midway, Murray, North Logan, North Ogden, North Salt Lake, Ogden, Orem, Park City, Pleasant Grove, Pleasant View, Provo, Riverdale, Riverton, Salt Lake City, Sandy, South Jordan, South Ogden, South Salt Lake, South Weber, Spanish Fork, Spring City, Springdale, Springville, Sunset, Syracuse, Taylorsville, Tooele, West Bountiful, West Haven, West Jordan, West Point, West Valley City, Woods Cross.